Transcend-information III Bedienungsanleitung PDF herunterladen (Seite 39)

4-8 CHAPTER 4: LOADING NETWORK DRIVERS

If you are running NetWare and you have installed multiple

3C592 EtherLink EISA adapters in an EISA-compliant computer,

follow these steps to install the NetWare ODI client driver:

1 Make sure your computer is turned off. Install the ﬁrst

adapter.

2 Connect the network cable to the adapter.

3 Insert the EISA conﬁguration utility diskette and turn on

the computer.

4 Run the EISA conﬁguration program.

5 When the program has ﬁnished:

a Save the conﬁguration.

b Remove the EISA conﬁguration diskette and exit the

program.

c Restart the computer.

6 Insert the EtherDisk diskette and run the AutoLink program.

Refer to the sections “AutoLink Requirements” and “AutoLink

Installation” earlier in this chapter for instructions.

7 When the AutoLink installation is complete, remove the

diskette, reboot the computer, and physically connect it to

the server if you have not already done so.

8 Turn off the computer, install the second adapter, and

connect the network cable to the adapter.

9 Insert the EISA conﬁguration utility diskette and turn on

the computer.

10 Run the EISA conﬁguration program.

11 When the program has ﬁnished:

a Save the conﬁguration.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 77 78

Keine Kommentare

Transcend-information III Bedienungsanleitung Seite 39